3d Printable 8 Port Mini Network Rack
The 4U 8 port network rack can be wall mounted or placed on a shelf for managing ethernet cables and holding your neworking equipment
which makes for a more efficient and accessible operating environment.
which makes for a more efficient and accessible operating environment.
Dimensions:
9"x5"x7"
The 8 port network rack is only available
in our 40 piece 3d printable tool set.
Needed Supplies
We created a list of things you might need to go along with our 3d Printable Network Rack
(We earn a small percentage of the sale if you purchase through these links)
1: NETGEAR 8-Port Gigabit Unmanaged Switch (GS308)
The NETGEAR 8-Port GS308 is what our Mini Network Rack was designed around.
Other 8 port switches might fit but we only tested with the NETGEAR 8 port. Check out this
NETGEAR 8-Port Gigabit Switch
For current pricing info.
Other 8 port switches might fit but we only tested with the NETGEAR 8 port. Check out this
NETGEAR 8-Port Gigabit Switch
For current pricing info.
2: M4 Asst Screw Set
These screws are needed to put our network rack together. You mostly just need the 12mm and 16mm screws but buying the set is cheaper than buying 12mm and 16mm screws, nuts and washers separately
- Screws
- Nuts
- Washers
M4 screw set with assorted sizes
For current pricing info.
3:RJ45 Keystone Couplers
You will need these if you already have ethernet cables already terminated with RJ45.
RJ45 Keystone Couplers
For current pricing info.
4:Punch Down Keystone Jack
You should use Punch Down Keystone Jacks if you are using solid core ethernet cables that will be going through a wall or a conduit and will be unlikely to be moved after installation
Check out thisPunch Down Keystone Jack set
For current pricing info.